9
8. Align flats on hammer base with
the slots in the hammer head guide
bushing until the 30mm open end
wrench will engage the flats (A) Fig.
27.
9. Engage the other 30mm open end
wrench with the flats on hammer
head as shown (B) Fig. 27 and tighten
as securely as possible.
PREPARING THE TOOL
1. After reading and understanding this entire manual, connect tool to
air supply. Fig. 28.
DANGER:
Never point tool at
yourself or others in work area.
Always connect tool to air supply
before loading fasteners (Fig. 28).
Operator and others in work area
MUST wear safety glasses with side
shields. Always wear ANSI Z87.1
approved safety glasses, and
hearing protection when preparing
or operating the tool.
Never use a tool that is leaking air, has missing or damaged parts, or
requires repair.
OPERATION
USING THE TOOL
Complete all steps of PREPARING THE TOOL before using the tool.
DANGER:
Never point tool at yourself or others in work area.
Never attempt to drive a fastener into material that is too hard, or at
too steep an angle, or near the edge of the workpiece. The fastener
can ricochet causing personal injury.
WARNING:
Disconnect tool from air supply before performing
maintenance, clearing a jammed fastener, leaving work area,
moving tool to another location, or handing the tool to another person.
WARNING:
Clean and inspect tool daily.
•
•
Fig. 25
Fig. 26
C
B
E
D
Fig. 27
A
B
Fig. 28
A
•
•
