6
GREEN
TO EARTH
RED
TO LINE 2
BLACK
TO LINE 1
CORD
CLAMP
FUSE
GREEN
TO EARTH
BLACK
TO LINE 1
RED
TO LINE 2
The wires in the mains lead are coloured in accordance with the following code:
Green & Yellow = Earth – Blue= Neutral – Brown= Live
As the colours of the wires in the mains lead of the appliance may not correspond with the
coloured markings, to identify the terminals in your plug, proceed as follows:
1. The wire which is coloured Green & Yellow must be connected to the terminal marked E
(Earth) or coloured Green.
2. The wire which is coloured Blue must be connected to the terminal marked N (Neutral) or
coloured Black.
3. The wire which is coloured Brown must be connected to the terminal marked L (Live) or
coloured Red.
The plug and socket must be accessible after installation. Should the mains lead ever need
replacing it is recommended that this operation is carried out by a qualified electrician who
will replace it with a lead of the same size and temperature rating.
1.7 CONVERTING THE GAS-SUPPLY TO THE HOB BURNERS
Burners: auxiliary, semi-rapid, rapid, triple crown, griddle burner.
These burners are all fitted with injectors designed to create a primary input of air gauged for
each type of gas. This means that the air regulator does not have to be regulated. Proceed as
follows in order to convert from one type of gas to another: remove the grids, covers, holed flame
diffuser and the burner supports (fig. 7); replace the holed injectors as indicated in 7/C according
to the type of gas used (see table 1); put the burner supports, flame diffusers, covers and grids
back in position; regulate the minimum output following the instructions in paragraph 1.7.
1.8 REGULATING THE MINIMUM OUTPUT OF THE HOB BURNERS
Normal/valve taps:
Ignite the burners and turn the knob to the maximum position. Remove the knob and insert a
small flat-head screwdriver into the rod or through the holes on the side of the control panel, in
accordance with the type (fig. 8 A/B). Loosen the by-pass screw by two turns in an anti-clockwise
direction and rotate the rod to the minimum position. Adjust the previously loosened screws until
the flame is lowered but stable, even when rapid changes are made from the maximum to the
minimum position with the burner cold. If safety taps are fitted, let the burner run on minimum for
a few minutes to ensure that the device does not cut in. If it does, increase the minimum.
N.B. For liquid gas settings, the burner minimum must be set by fully tightening the tap
by-passes.
Replace the knob and turn it to the minimum position, remove the knob and adjust the previously
loosened screw until the flame is lowered but stable, even when rapid changes from maximum to
minimum are made and the oven door is opened or closer quickly.
N.B. For liquid gas setting, the oven burner minimum is set by fully tightening the
thermostat by-passes.
Содержание FEC 90
Страница 1: ...Porter Charles OPERATION MANUAL Freestanding Gas Electric Cooker Slide In Freestanding FEC 90...
Страница 21: ...21 FIG 4 FIG 5 FIG 6 FIG 7 FIG 8 FIG 9...
Страница 22: ...22 FIG 10 FIG 10 A FIG 12 FIG 13 FIG 14 FIG 15 FIG 18 FIG 19 FIG 20...
Страница 23: ...23 FIG 21 FIG 22 FIG 23 FIG 24...
