Portawattz POWER PAC, Инструкция для владельца

Страница: 16 / 32

12
PORTAWATTZ PowerPAC Owner’s Manual
6.0 Powering 12 Volt DC Accessories
6.1 Connecting 12 Volt DC Accessories
The PowerPAC can operate any accessory that is intended to
run from a car’s cigarette lighter outlet. Simply insert the
accessory’s plug into the DC Power Socket on the PowerPAC’s
display panel. The PowerPAC’s DC Power Socket will operate
any 12 volt DC auto, marine or other 12 volt accessory that draws
12 amps or less. The following steps assume you have first fully
charged your PowerPAC’s battery according to instructions in
Section 8.0.
1. Plug the accessory into the PowerPAC’s DC Power Socket,
and switch the accessory on (if required).
2. The 12 volt appliance should operate until the battery runs
out of power.
3. If an accessory that draws more than 12 amps (or which is
defective and has a short circuit) is connected, an internal
circuit breaker will open after a short time and switch power
to the accessory off. If this occurs, unplug the accessory and
the breaker will automatically reset after a few seconds.
4. The DC Power Socket does not automatically switch off the
load when the battery is discharged. To protect the battery
against damage resulting from total discharge, it is strongly
recommended that the AC inverter is switched on, even when
powering 12 volt accessories only. This will enable the
inverter’s alarm to warn you when the 12 volt accessory has
nearly depleted the battery. The power used by the inverter
to monitor the battery will be negligible.
5. Fully recharge the PowerPAC battery as soon as possible
after each use.