6
Bracket
Screws
ASSEMBLY INSTRUCTIONS
Black (live)
White (neutral)
Bare/Green (ground)
Black
Blue
White
Green
7
6
5
7. Temporarily lift the motor housing up to the mounting
bracket to determine which two mounting screws in
the sides of the mounting bracket align with the J-slots
in the top edge of the motor housing. Partially loosen
the two mounting screws that align with the J-slots.
Remove the other two mounting screws from opposite
sides of the mounting bracket. Lift the motor housing
over the motor aligning the J-slots in the motor housing
with the loosened mounting screws in the mounting
bracket. Twist the motor housing clockwise to lock. Then
re-insert the two previously removed mounting screws
and tighten all four mounting screws.
8
8. Partially insert three blade screws, along with the
blade washers, through the blade and into the blade arm.
Tighten each blade screw, starting with the one in the
middle. Repeat this step for the remaining blades and
blade arms.
Blade
Washer
Blade Arm
Blade
Screw
Mounting
Screw
Mounting
Bracket
J-Slot
Motor
Housing
6. Use wire connectors to connect the fan wires to the
power supply wires according to the wiring diagram and
the following instructions:
• Connect the green wire from the lower bracket to the
bare/green (ground) supply wire.
• Connect the white wire from the fan to the white
(neutral/common) supply wire.
• Connect the black and blue wires from the fan to the
black (live/hot) supply wire.
Note:
If there is a second hot/live wire coming from the
outlet box, connect it to the Blue (light power) wire from
the fan for separate light and fan control.
Important:
After the connections have been made, the
connected wires should be turned upward and pushed
carefully up into the outlet box. Place the black and white
wire connections on opposite sides of the outlet box.
Wire Connector
5. Secure the lower bracket to the mounting bracket with
the three bracket screws.
Warning:
Do NOT control the fan
speed with a full-range dimmer switch.
