24
RAIL SAW SR-10-26-O & SR-10-26-1
ORIGINAL OPERATION MANUAL
6.5
Saw Mounting
1.
Holding the saw by the transport handle (1) with pivot arm hanging down (2), slide the exposed spindle into the clamp’s
mast (3).
2.
Allow the saw to swing into a hanging position.
3.
Install saw mounting nut (4) on spindle and tighten.
Figure 4 Saw mounting
6.6
Connecting hoses
Wipe quick couplers with a clean lint free cloth before connecting them.
1.
Connect hoses from power source to the tool. It is recommended that you connect the return hoses first and disconnect last
to minimize or avoid trapping pressure within the tool.
2.
When connecting the quick couplers, the flow should run from male coupler to the female coupler. The female coupler on
the tool is the inlet. Quick couplers are marked with a flow direction arrow.
3.
Turn the power source on and activate the flow to the tool.
