Page 16 Emhart Teknologies - 50 Shelton Technology Center, Shelton CT 06484 - Tel. (203) 924-9341 - Fax (800) 225-5614
Figure 10:
Proper insertion of POP NUT™ threaded inserts into an application
*Disengaging the tool from the insert
•
If you let go of the trigger during the installation sequence, the hydraulics will reset, the insert may
not set completely and the tool will not unthread from the insert. Do not pull the trigger again,
follow the steps below to disengage the insert.
To disengage the tool from the insert and application:
1. Depress and hold the Control Knob
2. While holding the Control Knob, press and hold the trigger. This will cause the Mandrel to spin
counter-clockwise and unthread the insert.
3. When fully unthreaded, release the trigger.
To disengage the tool from the insert and work piece if the Mandrel is stuck:
1. Disconnect the air supply
2. Thread the M4 x20 Cap screw provided with the tool, into the hole in the side of the Nose
Housing. Thread the Cap screw in until if fits snugly against the inner Spin Pull Head, locking
the rotatioin of the Mandrel to the tool.
3. Turn the body of the tool counter-clockwise to detach it from the insert.
Figure 11:
Disengaging the tool from the insert
OK
Not OK
Gap
Not OK
ROTATE
1. Control Knob
2. Trigger
Cap Screw
Nose Housing
Spin Pull Head
