Page 12 Emhart Teknologies - 50 Shelton Technology Center, Shelton CT 06484 - Tel. (203) 924-9341 - Fax (800) 225-5614
Tool Setup
Initial Setup
1. Check that the correct Nosepiece and Mandrel are fitted for the POP NUT™ to be installed. See
the
Basic Tool Operation
section for proper tool adjustment.
2. Connect an air fitting to the Swivel Air Fitting of the tool. The Swivel Air Fitting is a 1/4 NPTF
thread.
3. Connect an Air Hose to the tool.
4. Connect an air filter, regulator and lubricator inline with the air supply, between the Air Supply and
the Air Hose, within 3m [6 ft ] of the tool.
5. Adjust the air pressure supply and oil drip volume of the lubricator
•
Air Pressure: 0.5-0.6 MPa. (72.5-87 psi)
•
Oil drip volume: 1-2 drops/ 20 nuts fastened
Figure 3:
Tool Setup
Note:
Refer to the instruction manual for the Lubricator used for the proper adjustment method and
lubrication oils to use relating to air motors.
Note:
the tool may be manually lubricated if an oil lubricator is not available.
WARNING!
Use an air hose with a rating of 1.0 MPa (145 psi / 10 bar) or greater, maximum ordinary operating
pressure. Also make sure the hose material is suitable for the operating environment (i.e. oil proof, wear
and abrasion resistance etc.). For details, refer to your hose manufacturer's catalog.
