15
4. INSTALLATION
5. OPERATING THE PUMP
5.1
Setting the Clock
When the pump is first installed,it is necessary to set the clock.Any daily schedule set by
the user must be based on accurate time setting.
To Set the Clock:
1. When the pump is plugged in, the TIME led light is blinking. Entering clock setup by
pushing Display key.
(Time setup will be unavailable after 5 seconds’ blinking. Note:Pump must be
plugged out and ensure the lights on panel all go out, then re-plug it to enter the
setup and operate step 1.)
2. Use the
(<)
and
(>)
arrows to choose between a 12 or 24 hour time format.
3. Use the
(+)
and
(-)
arrows to change the time to the correct time of day. In the 12
hour time format AM/PM will display in the bottom left corner.
4. Press Display to exit the Clock Setup menu. The clock is now set.
During a power outage, the drive will retain the clock setting in memory for as long as
one week. If the power is out longer than one week the clock will have to be set again.
(Pump must be plugged out and ensure the lights on panel all go out, then re-
plug it to enter the setup and operate step 1.)
NOTE:
When power is returned to the pump after a prolonged outage (one week) the
clock will automatically set itself to the Speed 1 start time, blink and advance. The
pump will also run the associated schedule from that start time.