L0311 Rev 3 6-21
© Latham Pool Products, Inc. 2021. All rights reserved.
Page 6 of 9
Standard Setup Procedure (cont.):
3. Tap under Company Name to input a desired name.
4. Tap under Telephone to input a telephone number.
5. Tapping the button under the brand logo will allow switch between Coverstar and Pool Cover Specialists logos.
User Settings
1. Log into the device using any user code and navigate to the Setup Menu.
2. Select User Settings to enter the settings screen.
3. Adjust the Key Beep, Screen Timeout, and Screen Brightness to the desired settings.
4. Enter the Set Time screen using the on screen button and verify time and date are set correctly. Adjust time and
date as needed.
WiFi Setup:
1. On the Primary device, log in with any user and navigate to the Setup Menu.
2. Select WiFi Setup to enter the WiFi menu, then select WiFi Setup.
3. Take note of the MAC ID displayed on the bottom of the screen. This is required when registering a device for
notifications.
4. Select the desired WiFi network name (SSID), then enter the password using the on screen keyboard.
5. Press Test to check settings and attempt a network connection. If successful the device will list
“
Connected to Wifi
successfully.
”
If there was an error connecting check the password and try again.
6. After a successful test select Save to store you settings.
7. To complete the connection to WiFi a reboot is required. Log in using the Maintenance Passcode and navigate to
the Setup Menu, then the Maintenance menu. In the Maintenance Menu select the Reboot button to restart the
device.
8. After approximately 5 minutes the device will finish connecting to the WiFi network. Once
connected, the WiFi icon on the top left of the device will change from a disconnected icon to a
connected icon.
Coverstar Connect:
1. Navigate to Connect.Coverstar.com on your laptop, phone, or preferred device with an internet browser.
2. If you do not have an account, select Create an account to sign up. Otherwise log in using your email and password.
3. Add a Touch Controller by selecting Add a Device [A]
4. An Edit Device Screen will display with the information below.
5. [B] Is the Device Name that will display for notifications.
6. [C] Is the MAC address for the device being added. To find the MAC ID for your
device, On the Touch Controller go into Setup -> WiFi Setup -> WiFi Setup and
read the ID displayed. If the message
“
The Device ID is not authorized
…”
is
displayed, contact Latham to authorize your device.
7. [D] are the usernames that will be sent when a
notification is sent for that user.
8. [E] is the Email and is the Mobile Phone number where
notifications will be sent.
9. [F] Events are the notification types that are supported
to send. Which notifications and how frequent are
selected here.
10. [G] will save all entered settings to the account.
Over The Air (OTA) Update:
Over the air updates allow you to update device firmware
wirelessly using an internet connection. OTA updates allow
for bug fixes and additional features to be added to the
device. To perform an OTA a device with WiFi, an internet
browser, and an update file (.bin) is required.
A
B
C
D
E
F
G