Pontiac 2008 Wave, Руководство пользователя

Страница: 170 / 380

When the system is on, press and release this knob to
mute the system. Press and release this knob again to
turn the sound back on.
The previous volume setting is maintained whenever the
radio is turned on. The volume can be adjusted by using
the volume knob.
Finding a Station
AM/AUX: Press this button to play an AM station while
a portable audio device is playing. Press this button
again and the system will begin playing audio from the
connected portable audio player. If a portable audio
player is not connected, “no input device found” will be
displayed.
FM: Press this button to switch between FM1 or FM2.
The display will show the selection.
¦¥
SEEK: Press the up or down SEEK arrow to go
to the next or to the previous station and stay there.
The radio will only seek stations with a strong signal that
are in the selected band.
¦¥
TUNE: Press the up or down TUNE arrow to go
to the next or to the previous radio station.
SCAN: Push and release this button to scan radio
stations. The radio will go to a station, play for a
few seconds, then go on to the next station. Push this
button again to stop scanning.
The radio will only scan stations with a strong signal
that are in the selected band.
Setting Preset Stations
Up to 36 stations (six FM1, six FM2, six FM-A and
six AM1, six AM2, six AM-A), can be programmed on
the six numbered pushbuttons, by performing the
following steps:
1. Turn the radio on.
2. Press AM/AUX to select AM1, AM2, or AM-A. Press
FM to select FM1, FM2 or FM-A.
3. Tune in the desired station.
4. Press and hold one of the six numbered
pushbuttons for longer than two seconds. The
channel number (CH#1 through CH#6) will flash on
the display when the station has been set.
Whenever that numbered preset button is pressed,
the station that was set will return.
5. Repeat the first four steps for each preset button.
3-56