Pontiac 2007 G6, Руководство пользователя

Страница: 334 / 486

See Engine Compartment Overview on page 318
for more information on location.
1. Remove the dipstick and wipe it with a clean
rag or paper towel.
2. Reinstall it back in all the way, wait three
seconds and then pull it back out again.
3. Check both sides of the dipstick, and read the
lower level. The fluid level must be within the
crosshatched area.
4. If the fluid level is in the acceptable range,
reinstall the dipstick back in all the way.
How to Add Automatic Transaxle Fluid
Refer to the Maintenance Schedule to
determine what kind of transaxle fluid to use. See
Recommended Fluids and Lubricants on page 442 .
If the fluid level is low, add only enough of the
proper fluid to bring the level into the crosshatched
area on the dipstick.
1. Remove the dipstick.
2. Using a long-neck funnel, add enough fluid at
the dipstick hole to bring it to the proper level.
It does not take much fluid, generally less
than a half pint (0.24 L). Do not overfill.
Notice: Use of the incorrect automatic
transaxle fluid may damage your vehicle, and
the damages may not be covered by your
warranty. Always use the automatic transaxle
fluid listed in
Recommended Fluids and
Lubricants on page 442 .
3. After adding fluid, recheck the fluid level as
described under “How to Check Automatic
Transaxle Fluid,” earlier in this section.
4. When the correct fluid level is obtained,
reinstall the dipstick back in all the way.
334