WAT E R G A R D E N I N G T O T H E M A X
TM
UV-C
WATER CLARIFIER
ASSEMBLING / REPLACEMENT OF UV-C LAMP
To perform this operation properly, it is recommended to carefully follow the instructions below:
1. Switch PondMAX
® UV-C Water Clarifier off, disconnecting the power cord plug from the electrical socket.
2. Hold the unlock button (8) and turn the ballast assembly (9) counterclockwise so that the indicator on the unlock button can move from the
closed lock to the open lock position (Fig. 12 Page 7).
3. Remove the ballast assembly (9) from the main body (1).
4. Remove the safety screw (7) and unscrew the clamp ring (6) (Fig. 13).
5. Carefully remove the quartz tube (2) from its seat.
6. Remove the UV-C lamp (3) from the package and install into the lamp electrical socket, slightly pressing on it, until you hear a click, that confirms
the proper installation (Fig. 14).
WARNING: When replacing the UV-C lamp installed during the first installation with a new one, the plastic support provided in the new lamp package
must be removed, since it is not intended for use in PondMAX
® UV-C Water Clarifier filter. Use a clean cloth or tissue to hold the UV-C lamp in order to
extend the life of the lamp.
WARNING: Check the condition of the quartz tube O-ring (4). In case of poor elasticity, flattening or rupture, replace it, taking it out from the seat and
slipping it along the entire length of the quartz tube. Install a new O-ring proceeding in the reverse order. It is recommended to use only original spare
parts, because thanks to the special materials these parts ensure safe and long-term performance of the filter (Fig. 15).
7. Put the ballast assembly on a flat supporting surface, install the quartz tube (2) into its seat and fasten the clamping ring (6) up to the stop (the
tooth on the fastening nut runs against the seat of the safety screw located on the ballast assembly) (Fig. 16 Page 7).
8. Fasten the safety screw (7) (Fig. 17).
9. Insert the ballast assembly (9) into the main body (1) so that the indicator on the unlock button (8) corresponds to the open lock image.
10. Turn the ballast assembly (9) clockwise, until the indicator on the unlock button corresponds to the closed lock image (Fig. 18).
11. Connect the PondMAX
® UV-C Water Clarifier to the electrical socket.
1
3
2
Fig. 12
Fig. 13
1
2
3
1
2
3
9/18W
24/36/60W
Fig. 15
click!
Fig. 14
Fig. 16
1
2
1
2
9/18W
24/36/60W
Fig. 17
9/18W
24-36-60W
Fig. 18
Page 7
1
WAT E R G A R D E N I N G T O T H E M A X
