
Appendix 1: Terms and Definitions
SN
Terms
Definition
Comment
1
Printing delay
It is the distance from the point when
photocell senses the printing object
to the point when printing starts.
User can adjust the right print
position on printingobject.
E.g. Printing delay value is 30mm,
printer starts printing at 30mm point after
the photocell senses the printing object.
2
Printing
initial value
Counter Initial value during
printing
E.g. Set the initial value as 9, the counter
counting starts from 9 for first print.
3
Screen
saver time
It is a power saving function, the
screen will automatically turn off and
enter standby mode when the screen
is inactive for a while as set.
E.g. Set the screen saver time as one
minute. The screen will automatically
turn off and enter standby mode if the
screen becomes inactive for one minute.
4
the date
transition
time
customer can set a date for change
For example: Date change setting is
“08:00” ,Current date is 10/07 change
the time to 07:59,then the time of last
printing out before that is recorded as
09/07 07:59, after that is 10/07,8:00. If
the date transition time is 12:01,then the
time of last printing out before that is
recorded as 10/07 12:00,after that is
11/07.
5
Pre-purge
Nozzles become dry and cause
first half charactera unclear. user
can turn this function ON to
prevent the situation,
When Pre-purge function is turned ON,
printer will spray a little ink during idle
printing status to keep nozzle wet and
prevent dry.
6
One key
cleaning
Customer can use this function to
purge nozzles.
Purge whole nozzle to make sure
nozzles unblocked.
7
Channel
switch
Customer can switch different
channels to achieve best print
quality according to print need and
nozzle condition.
E.g. Option for single-channel printing,
when damage in left channel nozzle or
missing dots in print by left channel,
user can switch to right channel
printing.
Option for dual-channel printing to
achieve darker print and best print
quality.
8
Continuous
printing
Continuous same data printing
during the period that photocell
sensing the print object.
9
Printing
Recovery
When there is a power failure, and
the setting is "ON", system will go
back to the last printing status and
resume printing when power gets
back. The default setting for this
function is "OFF"
When the printing contains counter,
and the Printing Recovery setting is
"ON", operator need to check on the
counter value and do needful
adjustment.
4
2