PolyScience LX, Руководство оператора

Страница: 22 / 24

20 110-874
For optimum temperature stability, the fluid’s viscosity should be
50 centistokes (cSt) or less at its lowest operating temperature.
This permits good fluid circulation and minimizes heating from
the pump.
WARNING: DO NOT USE THE FOLLOWING
LIQUIDS:
• Automotive antifreeze with additives**
• Hard tap water**
• Deionized water with a specific resistance >1 meg
ohm
• Any flammable fluids
• Concentrations of acids or bases
• Solutions with halides: chlorides, fluorides,
bromides, iodides or sulfur
• Bleach (Sodium Hypochlorite)
• Solutions with chromates or chroium salts
• Glycerine
• Syltherm fluids
** At temperatures above 40°C, additives or mineral
deposits can adhere to the heater. If deposits are allowed
to build up, the heater may overheat and fail. Higher
temperatures and higher concentrations of additives will
hasten deposit build up.
!
Equipment Disposal (WEEE Directive)
This equipment is marked with the crossed out wheeled bin symbol to indicate
it is covered by the Waste Electrical and Electronic Equipment (WEEE)
Directive and is not to be disposed of as unsorted municipal waste. Products
marked with this symbol must be collected separately, according to the
regulatory guidelines in your area.
It is your responsibility to correctly dispose of this equipment at lifecycle-end
by handing it over to an authorized facility for separate collection and recycling.
It is your responsibility to decontaminate the equipment in case of biological,
chemical and/or radiological contamination, so as to protect the persons
involved in the disposal and recycling of the equipment from health hazards.
Requirements for waste collection, reuse, recycling and recovery programs
vary by regulatory authority at your location. Contact your local responsible
body (e.g., your laboratory manager) or authorized representative for
information regarding applicable disposal regulations.