FILTER PUMP OPERATION
1. Plug the GFCI power cord to a properly grounded receptacle. It is recommended that the outlet is at least 15 feet (4.5m)
away from the pool.
2. IMPORTANT: To start the filter pump, press the RESET button on the GFCI plug .
3. Check the return fitting on the inside of the pool for correct flow, it should feel like a solid stream of water returning to the pool.
You can use the return flow as a gauge to determine when the filter needs cleaning or replacement. If you feel a reduction in
flow, clean or replace filter.
4. Test water and adjust as needed, read Section 9 - “POOL WATER CARE”. VERY IMPORTANT – FILTER PUMP ALONE WILL
NOT PREVENT ALGAE FROM GROWING IN POOL WATER; THIS CAN ONLY BE DONE BY MAINTAINING PROPER
CHLORINE AND pH LEVELS AT ALL TIMES!
5. The filter cartridge may need to be cleaned and/or replaced several times at start up until the correct chlorine and pH levels
are attained. We recommend that you keep at least one spare filter cartridge on hand at all times. Filter cartridges may be
purchased at the store you purchased your pool from, or ordered from Polygroup
®
at polygroupstore.com.
6. To turn off the filter pump, press the test button and unplug the GFCI power cord .
Press
"RESET"
Button
To Start
Pump
Operation
How to use the GFCI plug
*Do not connect
to a timer device
Max. Level
Min. Level
9. Fill the pool with water. Continue filling the pool until the water has reached the proper level. Plug in the GFCI, press the reset button to start the pump and enjoy
your pool.
Weir installation
finished.
a) Insert the weir pin
into the proper hole.
b) Push the weir
pin into the hole.
c) Retract the other weir pin, then release to
put it into the proper skimmer hole.
Push here
Push-in
The Filter Cartridge may
hold 1" diameter chlorine
tablets. Check your chlorine
levels to determine the
proper number of chlorine
tablets to add.
5
9
7. Install weir
8
onto the canister. Make sure the weir
foam insert is facing inside the canister.
8. Slip the Top Cover
5
onto the skimmer canister
9
.
10
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
MST. Extended operating days and hours during peak season requirements.
Inside Pool Wall
Inside Pool Wall
Inside Pool Wall
The water level should be
between the min and max
markers located inside the
skimmer canister ring.