Polygroup SUMMER WAVES SKIMMERPLUS SFX1000-BS, Руководство пользователя

Страница: 10 / 18

FILTER PUMP OPERATION
1. Plug the pump transformer to a properly grounded receptacle at least 15 feet (4.5m) away from the pool.
2. Check the return fitting on the inside of the pool for correct flow; it should feel like a solid stream of water returning to the pool. You can use the return flow as a
gauge to determine when the filter needs cleaning or replacement. If you feel a reduction in flow, clean or replace filter.
3. Test water and adjust as needed, read - “POOL WATER CARE”. VERY IMPORTANT– FILTER PUMP ALONE WILL NOT PREVENT ALGAE FROM GROWING IN
POOL WATER; THIS CAN ONLY BE DONE BY MAINTAINING PROPER CHLORINE AND pH LEVELS AT ALL TIMES!
4. The filter cartridge may need to be cleaned and/or replaced several times at start up until the correct chlorine and pH levels are attained. We recommend that you
keep at least one spare filter cartridge on hand at all times. Filter cartridges may be purchased at the store you purchased your pool from, or ordered from Polygroup
®
.
5. To turn off the filter pump, unplug the transformer power cord.
Water Level
Max. Level
Min. Level
9. Fill water to a proper level, Connect the transformer and extension power cord from the motor assembly and then tighten the screw nut by hand, plug in the
pump, and enjoy clean pool water.
Weir installation
finished.
a) Insert the weir pin
into the proper hole.
b) Push the weir
pin into the hole.
c) Retract the other weir pin, then release to
put it into the proper skimmer hole.
Push here Push-in
The Filter Cartridge may
hold 1" diameter chlorine
tablets. Check your chlorine
levels to determine the
proper number of chlorine
tablets to add.
5
8
9
7. Install weir 8 onto the canister. 8. Slip the Top Cover 5 onto the skimmer canister 9 .
Screw Nut
SFX600-BS-12V
SFX1000-BS-12V
SFX1500-BS-12V
10