The currently loaded pattern will play until the end of that pattern.
If there is another pattern programmed into the next adjacent pad, it will play
immediately after the previous pattern ends, and so on, until it reaches an empty
pad, or until the last available pattern slot.
After playing the last pattern in a sequence, playback jumps back to the first
pattern in this particular sequence.
To switch patterns
immediately
, press the grid pad while holding Pattern or Shift.
To copy a pattern, press and hold the source slot and select the destination target slot
by shortly pressing it.
To delete patterns, press and hold corresponding grid pads and use the Delete
command (Shift + Fill key combo).
The pattern to be played next (triggered by hand or by playing the pattern sequentially)
will flash orange and light blue.
Only one pattern at a time may be copied.
Important:
It is not necessary to leave Pattern mode to use the knob modulators. Just select the
tracks you want to edit and use the knobs to modulate the existing step values while in
the Pattern mode.
When working on a single pattern in Play, the Chance/Action Play/Skip values always
trigger steps as it was the first loop iteration. This will work differently when creating
chains in the Pattern mode.
You can use variations from the Pattern mode level too.
Toggling between Patterns and Perform mode is not disabling the Perform effects.
https://www.youtube.com/embed/piPCtVK2mc8?feature=oembed
Perform Mode