Polycom HDX 9002, Настройка

Страница: 30 / 38

Setting Up the Polycom Instructor FS HDX
24
Power On the System and Install the Software
Power on the PC.
Power on the flat-panel display by pressing the
button on the back left corner of the display.
Set the PC’s resolution to 1024x768 60Hz.
Press the
AV
button on the Sampo remote
control that you received with the
flat-panel display, and then select
RGB
.
This will enable you to use the Sampo flat-panel
display as the PC’s monitor.
Power on the HDX 9002 by flipping down the
flap on the front of the system and pressing
the power button.
Take note of the IP address that appears on the
home screen of the HDX 9002 system. If the IP
address does not appear on the home screen,
you can find it by going to System > Admin
Settings > LAN Properties.
1
2
3
4