Poly EduCart 2 Setup Sheet
3
Only the EduCart 2 components and customer-
supplied display should be plugged into the power
bar outlet. Do not power any other electrical
equipment from this power bar outlet.
5
Insert the top M3 x 8 stainless steel Phillips pan head
screw through the back of the codec mounting plate.
Align the top right corner of the codec with the top right
corner of the codec mounting plate (circled in red). This
aligns the top hole in the bottom of the codec with the
screw. Tighten the screw.
Insert the bottom codec mounting screw into the bottom
hole in the rear of the codec. Tighten the screw.
6
Attach and route the cables as shown below using the supplied cable ties
and attachment points (circled in red) on the codec mounting plate.
Run the left and right speaker cables down the adjacent poles and exit at
the appropriate locations for connection to the speakers.
A power bar outlet and IEC adapter cable are provided with the system
for powering the display. Run the power cord from the power bar outlet,
down the adjacent pole, and exit the cord end at the hole at the bottom of
the pole. Run an Ethernet cable the same way.
Store excess cable with the cable wrap bracket at the bottom of the cart
base.
Refer to the wiring diagram at the end of this document for details.
Codec
Power supplies
are on other
side of codec
Camera plate
points towards
the power supply side
AC connectors
on bottom
