36
Door Kit HT3004 w/ Metal Frame Installation – Part 3
Refer to Contents of Door Kit HT3004
Lay out the Reinforced Poly Door (HT1014)
on a flat surface.
Insert the Roll-Up Tube w/Snap (RC1007) into
the Tube Bottom Extension (RC1026). Slide the
assembled tubes into the sleeve at the bottom
of the Poly Door.
Secure the Poly Door to the Door Tube using
Roll-Up Tube Clips (RC1010) approximately
every 36
. Set the Poly Door with Tube in
the Cradles.
Lift the free end free end of the Poly Door to
the top of the door frame and secure with Wig-
gle Wire. Be sure to center the door over the
opening. Note: It is important that the Roll-Up
Door Tube is still resting in the Cradles after the
Wiggle Wire has been installed along the top.
Using the Grommets in the Poly Door as a
guide, drill three 3/8
holes through the Wiggle
Wire Base and Wood Jamb on each side of
the Door. Insert a 3
Carriage Bolt (NB1841)
with the threaded end facing outside. Add lock
washer and hex nut and tighten. Install a Ball
Knob on threaded ends. Loop the Bungee
Cords over the Ball Knobs. See Detail 2.
Install U-Joint (RC1303) onto the end of the
Roll-Up Tube using a 5/16
x 1-3/4
hex bolt
and lock nut through the hole. Attach Roll-Up
Crank (RC1314) to the end of the U-Joint using
a 5/16
x 1-3/4
hex bolt and lock nut. Install
door “J” Hook (FT2071) to retain the Roll-Up
Crank when door is rolled up.
Check the operation of the Poly Door by un-
hooking the Bungee Cords and rolling up the
Poly Door to the top grommet elevation.
Insert a loose Bungee Cord into the center
hole of the Door. Wrap the cord around the
rolled up part of the door and insert the Ball
through the loop of the cord. Do same at left
and right grommets.
Roll-Up Tube
w/Snap RC1007
Tube Bottom Extension
RC1026
Snap Button
Door (10
x 8
) w/Bungee
HT1014
Roll-Up Crank
RC1314
Tube Clips
RC1010
U-Joint
NB5000
Roll-Up Door
Tube
Roll-Up Door Tube
(assembled)
5/16
x 1 3/4
Hex Bolt NB1847
& Lock Nut NB1751
Detail 1
Detail 3
Detail 2
3
Carriage Bolt NB1841
Lock Washer NB1864
Hex Nut NB1874
Six, (6) places
Bungee Cord wraps around
threaded carriage bolt
Threaded
Ball
Door "J" Hook
FT2071
1
2
3
4
5
