POLTI VAPORELLA VERTICAL STYLER GSF60, Инструкция по эксплуатации

Страница: 20 / 64

the main device.
1.8 Insert the power plug into a suitable
earthed socket (13). The indicator on the front
of the main device will light up when connec-
ted to the mains.
1.9 Press the ON/OFF switch (14): the device
will make a sound and the steam regulator
LED will light up.
2. STEAM ADJUSTMENT
Vaporella Vertical Styler is ideal for refreshing
fabrics, removing creases and eliminating or-
ders, even from household textiles. Always
check the instructions on a garment’s tag
before steaming.
Using the table below, select the appropriate
amount of steam for the fabric to be ironed or
refreshed by turning the adjustment dial (15):
3. USE
3.1 Be sure to follow the directions in Sec-
tion 1.
3.2 60 seconds after switching ON (14), the
device head will begin continuously produ-
cing steam (16).
3.3 Adjust the amount of steam (15) as in-
structed in Section 2.
3.4 You may now begin steaming the fabric.
3.5 It is best to move from top to bottom.
3.6 To remove creases, press the metal steam
head on the fabric; for easier operation, stret-
ch the fabric in the opposite direction (17).
3.7 For shirt sleeves, stretch the sleeve and
pass the steam head from top to bottom.
3.8 To revive heavier fabrics, attach the fabric
brush to the steam head (18). The bristles
open the fibres of more resistant fabrics (like
jackets, coats and textiles), allowing the
steam to work deeper and stretch them.
3.9 The built-in garment hanger makes it easy
to use Vaporella Vertical Styler with various
garments and fabrics. Hang jackets and coats
directly on the garment hanger. For large tex-
tiles (like tablecloths and linens), use the
lower metal bar (19). Hang shirts and dresses
directly on the centre hanger (20).
3.10 To get the best results with shirts, button
the first button so they hang evenly.
4. OUT OF WATER
If the device stops producing steam, the wa-
ter in the tank has been used up.
Just refill the water tank, as described in Sec-
tion 1, to begin steaming again.
5. GENERAL MAINTENANCE
Before carrying out any maintenance on the
device, always unplug it from the power
mains making sure that the product has
cooled down before proceeding.
To clean the outside of the appliance, only
use a damp cloth.
Do not use detergents of any type.
6. STORAGE
6.1 Turn off the appliance and disconnect
from the mains electricity.
6.2 Wait for the appliance to cool down
completely before storing it.
6.3 Empty the water tank.
6.4 Replace the hose by hanging it in the
hooks on the metal tubes.
6.5 To remove accumulated water in the tank
compartment, place a container under the ac-
cess valve on the left side of the device. Un-
screw the valve in the direction shown until
water begins to come out (21).
ATTENTION: The hose will heat up while in
use. This is completely normal.
1 SYNTHETIC •
2 VELVET •
3 SILK ••
4 WOOL ••
5 COTTON •••
6 LINEN •••
If the fabric is very delicate, keep the metal
steam head from touching the garment.
WARNING: Steam.
Risk of scalding!
E
N
G
L
IS
H
| 20 |