FORZASPIRA C110
16
ENGLI
SH
CORRECT USE OF THE PRODUCT
This appliance is intended for home use for
vacuuming solids as described and in accor-
dance with the instructions provided in this
manual. Please read these instructions care-
fully and keep them, as you may find them
useful in future.
Polti declines liability for any damage or
accident derived from any use of this ap-
pliance which does not comply with the in-
structions contained in this booklet.
ATTENTION
Directive 2002/96/EC (Waste Electrical and
Electronic Equipment - WEEE): information
for users
This product complies with EU Directive
2002/96/EC.
The crossed-out wastebasket sym-
bol on the appliance means that at
the end of its useful lifespan, the pro-
duct must be disposed of separately
from ordinary household wastes.
The user is responsible for delivering the ap-
pliance to an appropriate collection facility at
the end of its useful lifespan.
Appropriate separate collection to permit
recycling, treatment and environmentally
compatible disposal helps prevent negative
impact on the environment and human health
and promotes recycling of the materials
making up the product. For more information
on available collection facilities, contact your
local waste collection service or the shop
where you bought this appliance.
PREPARATION
♦ Remove the appliance from the packaging,
checking that the product is whole and that
all the parts are there.
♦ Insert the suction opening of the flexible
tube (
A
) into the connector (
9
) (Fig. 1) (to
disconnect it, press the buttons (
A3
) and
pull the tube Fig. 2).
♦ Unwind the power supply cable (
1
) and in-
sert the plug into a suitable power socket.
♦ Press the ON/OFF switch (
10
). The ap-
pliance will start to operate. The ON/OFF
switch (
10
) can be pressed with your foot to
avoid having to bend over.
♦ You can adjust the suction power with the
cursor (
3
). Move it to the right to increase
the suction power. To reduce it, just move
the cursor to the left (Fig. 3). We suggest
minimum level for curtains, medium-low for
sofas, armchairs and pillows, medium-high
for carpets and high for floors and hard sur-
faces (ceramic, marble etc.).
♦ With the manual suction regulator (
A2
) it is
possible to intervene promptly in case of an
accidental suction (i.e. curtains) by redu-
cing the suction power. We recommend
operating the appliance with the regulator
open on curtains, rugs, sofas, etc. Move the
regulator forward until the hole is exposed
on the handle. To return to maximum
power, move the regulator backwards until
the hole is covered.
♦ To end suction, press the ON/OFF switch
again (
10
).
EMPTYING AND CLEANING THE DUST
CONTAINER
♦ Switch off the appliance using the ON/OFF
switch (
10
). Disconnect the power supply
cable (
1
) from the mains.
♦ Unhook the dust container from the vacuum
cleaner by opening the cover (
5
) and pres-
sing the dust container release button (
5a
)
(Fig.5).
♦ Remove the dust container (
7
) lifting it by
the handle (
6
).
♦ Press the button (
8
) located on the contai-
ner (
7
) in order to open the container and
remove the dirt collected (Fig. 6).
ATTENTION:
since by operating the button
(
8
) the lower base of the reservoir opens, it
is recommended that this operation be do-
ne over a waste bin.
