A R O M A
M I C H E L A N G E L O
7
EE
EE
NN
NN
GG
GG
LL
LL
II
II
SS
SS
HH
HH
•
Place the cup under the steam nozzle (
12
).
•
Press the steam preheat button (
10
). When the
system is ready, the words STEAM IS READY
and TURN VALVE will appear alternately on the
display.
•
Turn the steam/hot water knob (
11
) to the
right. Important: A little water will come out be-
fore the steam.
•
When steam starts to come out, open the knob
(
12b
); this will allow milk to be taken up and
frothed directly in the cup.
•
Use the intake knob (
12b
) to vary how wide the
valve opens and therefore the amount of milk
taken in. With the knob positioned as shown in
fig.C, that is, all the way open, milk is warm and
frothy; adjust the knob to an intermediate posi-
tion for less froth and hotter milk. Position the
knob as shown in fig. B to close the valve.
•
When this procedure has been completed, re-
turn the knob (
12b
) and the steam knob (
11
) to
their initial positions.
Warning – scalding steam hazard:
The steam is
very hot! Grasp the nozzle by the black plastic part!
Residues left on the nozzle after frothing milk are
hard to remove when dry, so it is a good idea to
clean the whole assembly as soon as it cools down.
Eliminate milk residues in the hole through which
milk passes in the knob (
12b
) with a needle.
Important:
after using the steam wand, it is impor-
tant to rinse the machine through before making
coffee again to cool down the circuit, or the aroma
of the coffee will be spoiled. Place a container un-
der the coffee dispensing nozzle (
8
) and press the
service button (
7
) or let a little hot water flow
through the nozzle (
12
).
PROGRAMMING
Use the following buttons under the display for pro-
gramming:
P
Programming mode
>
selection button
ok
confirmation button
exit
interrupt or conclude programming
The machine allows you to set the following func-
tions:
1. Filter
2. Water hardness
3. Temperature
4. Time (on time and off time)
5. Language
6. Statistics
1. FILTER
Filter assembly
The machine is supplied with a special filter acces-
sory for the water reservoir. The filter is made of
resins and protects the machine from lime scale
deposits, filtering out any substances (such as
chlorine and metallic residues) that can alter the
flavour and aroma of coffee, while leaving the min-
eral content of the water unaltered. For the ma-
chine to recognise the presence of the filter, you
must set the filter setting to YES. The factory set-
ting is no filter.
1b. Press the programming button
P
.
2b. Press the
>
button until PROGRAM FILTER ap-
pears on the display.
3b. Press
ok
.
4b. Press
>
until YES appears on the display.
5b. Confirm by pressing
ok
.
6b. The words FILTER CHANGE / TURN VALVE will
appear alternately on the display.
7b. Empty the water reservoir (
17
) and screw on
the filter using the filter assembly tool (
24
)
supplied with the portafilter (
21
).
8b. Fill the reservoir with cold water and put it
back inside the appliance..
9b. Place a recipient underneath the nozzle (
12
)
and turn the knob (
11
) to the right. The sys-
tem will perform a rinse cycle.
10b. Wait until water stops flowing out of the noz-
zle, then turn the knob (
11
) to the left again.
• The system quickly heats up and is ready
for use again.
• The service button (
7
) may carry on flash-
ing. If this happens, press the button (
7
) to
conduct another short rinse cycle through
the coffee outlet (
8
).
IMPORTANT:
The system must be programmed ei-
ther for use of a water filter or for the hardness of
the water and therefore the manual lime scale re-
moval cycle. You cannot use both of these settings
at the same time.
If you are using the filter on the machine and the
system is programmed to “YES”, water hardness
and manual lime scale programming cannot be dis-
played.
The filter loses its effectiveness after about 50
litres of water. Follow the instructions in the section
on “replacing the water filter” to replace it.
Important: If you have not used the machine very
much, you must replace the filter even if no indica-
tion appears on the display after a maximum of two
months (see the section on “manual filter replace-
ment (
25
)”).
Содержание AROMA MICHELANGELO
Страница 1: ...Michelangelo ...
Страница 16: ...15 E E E E N N N N G G G G L L L L I I I I S S S S H H H H N O T E ...
