A R O M A
M I C H E L A N G E L O
10
5g. Wait until no more water flows out of the noz-
zle, and then turn the knob (
11
) toward the left.
6g. The system will rapidly heat up and the coffee-
making symbol will appear on the display, indi-
cating that the machine is ready for use again.
Manual filter replacement (25)
Even if you make coffee infrequently, the filter must
be replaced at least every 2 months. No signal will
appear on the display, and the new filter must be re-
placed manually.
As a reminder, you may set the replacement date
on the wheel on the top of the filter.
1h. Empty the water reservoir (
17
) and replace the
filter.
2h. Fill the reservoir with cold water and put it back
in the machine.
3h. Press the programming button
P
.
4h. Press
>
until PROGRAM FILTER. appears on the
display.
5h. Press
ok
. The display will indicate MANUAL
RINSING.
6h. Confirm by pressing
ok
, and FILTER CHANGE
/TURN VALVE will appear alternately on the dis-
play.
7h. Proceed as described in point 4g. of the sec-
tion on “Replacing the filter (
25
)”.
Cleaning programme
The cleaning programme thoroughly cleans all dis-
pensing assemblies, removing coffee residues and
oily deposits which can build up and block up the
machine. To run the programme, use the special
tablets available at your Authorised Polti Service
Centre or home delivered by calling 01249-
815511.
IMPORTANT: This programme is intended
solely for cleaning the coffee dispenser as-
sembly. It is not a lime scale remover pro-
gramme; do not get the tablets for these two
uses mixed up.
When the machine requires cleaning, the words
PLEASE CLEAN will appear on the display, alter-
nately with the normal operation symbol, and the
service button (
7
) will flash.
RECOMMENDATION:
Press the service button on-
ly when you want to perform the cleaning cycle.
You may continue making coffee, hot water and
steam, but we recommend you perform the clean-
ing cycle promptly.
Important: The cleaning programme cannot
be interrupted once it has started.
1i.
Press the service button (
7
). EMPTY TRAYS
will appear on the display, alternating with
FILL WATER
2i.
Remove the drip tray (
9b
) and the water reser-
voir (
17
) and clean them thoroughly.
3i.
Fill the reservoir with cold water, and re-as-
semble the reservoir and trays on the ma-
chine.
4i.
The machine will perform a brief washing cy-
cle, and the indications CLEANING TAB INTO
and POWDER SHAFT will appear alternately on
the display.
RECOMMENDATION:
Place a dish of sufficient ca-
pacity (about 0.5 litres) under the coffee dispensing
nozzle (
8
).
5i.
Put the cleaning tablet into the powdered cof-
fee compartment (
20
) and close the lid. The
service button (
7
) will flash and PRESS S KEY
will appear on the display.
Important: do not put the cleaning tablet in
the water reservoir (17).
6i.
Press the service button (
7
).
7i.
The machine begins the cleaning procedure.
8i.
The cleaning procedure is automatic and
takes about 10 minutes. When the cycle has
been completed, EMPTY TRAYS will appear on
the display
9i.
Empty the drip tray (
9b
) and put it back in po-
sition.
10i. If necessary, fill the water reservoir (
17
) with
cold water.
11i. The machine quickly heats up to the right tem-
perature and is ready for use again.
Manual cleaning
If necessary, you can run the cleaning programme
even if the alarm does not appear:
1h. Press the programming button
P
.
2h. Press
>
until PROGRAM CLEANING appears on
the display.
3h. Press
ok
. The display will indicate MANUAL
CLEANING.
4h. Confirm by pressing
ok
, and EMPTY TRAYS/
FILL WATER will appear alternately on the dis-
play.
5h. Proceed as described beginning in point 2i of
the “Cleaning programme” section.
If you unintentionally start up the cleaning pro-
gramme, you can interrupt it at the beginning of the
EE
EE
NN
NN
GG
GG
LL
LL
II
II
SS
SS
HH
HH
Содержание AROMA MICHELANGELO
Страница 1: ...Michelangelo ...
Страница 16: ...15 E E E E N N N N G G G G L L L L I I I I S S S S H H H H N O T E ...