Politec Sandor Dual, Инструкция по установке и монтажу

Страница: 2 / 36

Table of contents
2
SANDOR PLUS SMA POLITEC | INSTALLATION MANUAL - VER.2.6
1.Introduction…………………………………………………………………………………………………………………………….……...3
2.Product description……………………………………………………………………………………………. ........ ……………..3
3.General warnings………………………………………………………………………………………………………………… ... …..…. 4
3.1 Additional warnings for devices powered by mains voltage
3.2 Installation warnings
4.List of main components ………………………………………………………………………………………… ......... ……………..5
5.Preparation for installation .................................................. ............................................................... 6
5.1 Preparation of the barrier parts before installation
5.2 It is advisable to carry out
6.Assembly / fixing examples ………………………………………………………. …………………………………… ... ………… .7
6.1 Installation placement and height
6.2 Placement and assembly
7.Evaluations before installation ………………………………… .. ……………………………………………… .. ….….… ..9
7.1 Introduction to barriers
8.Barrier positioning ………………………………………. ……………………………… .. …………………… .... …… .. …… .10
8.1 Precautions before installation
9.Installation examples …………………….…. ………………………………………………………………………………… ... 11
9.1 Barrier control
10.Wiring…………………………………..……………………………………………………………………………… .... ………… ... 12
10.1 Type of cable
10.2 Connection of cables from power supply to barrier
11.Connections to the terminal board……………………………………………………………………………………………….14
11.1 Wire synchronism
11.2 Connection for synchronism
12.Barrier alignment……………………………………………………..………………… ............... ………………………………..17
12.1 Calibration using SMA system
12.2 Alignment
12.3 Parallel beam calibration
12.4 Calibration with active crossing function
13.Optical synchronism ……………………………………………………………. …………………………………………….… ..… .21
14.Basic functions ………………………………………………………………… .. ……………
. ………………………………… ... ... 22
14.1 Basic settings and programming - MES9012 board
15.Intervention time adjustment…………………………………………………………………… ............ .…………..……......23
16.Appendix A: motherboard setting and programming (MES9012) …………… ....... ……………. ………… .... 24
16.1 Motherboard components
16.2 LED signal operation
16.3 Characteristics of settings
17.Appendix B: optical board configuration …………………………………………………….… .... . ……………………… 28
17.1 Transmitter optics
17.2 Receiver optics
18. Appendix C: configuration with 3/2 receivers …………………………………………………………. …………….… 30
18.1 Setting 3 RX models
18.2 Setting 2 RX models
19.Appendix D: serial connection to the Adebus concentrator …………. ………….…. …………… .. ………… .31
19.1 Serial port connection for each barrier
20.Appendix E: single barrier with optical synchronism ……. ………………. …………………… .. ……. ………… ..32
21.Technical characteristics ………. ……………. …………………………………………………………… .. ……………. …… ..33
22.F.A.Q………………………………….………………….……………………………………………………………………….…………….34
23.Product disposal ………………………………. ………. …………………………. …………………
.......... ………. …………… 36