Politec PARVIS HYBRID SMA, Техническое руководство, Страница: 2 / 24

POLITEC s.r.l. | Manual PARVIS HYBRID SMA – Ver. 1.2 2
INDEX
1 MAIN COMPONENTS Pag. 3
2 ASSEMBLING THE CABLEPIT Pag. 4
CABLE PIT POSITIONING Pag. 6
3 BASE INSTALLATION ON CABLEPIT Pag. 8
4 INSTALLATION EXAMPLES Pag. 9
5 WIRING Pag. 10
6 CONFIGURATION OF THE OPTICALS Pag. 11
OPTICAL TX Pag. 11
OPTICAL RX Pag. 12
7 SANDOR WS SMA TX MOTHERBOARD Pag. 13
8 SANDOR WS SMA RX MOTHERBOARD Pag. 14
9 SETTINGS & FUNCTIONS Pag. 15
DIP SWITCHES Pag. 15
10 COLUMN ALIGNMENT Pag. 19
11 CALIBRATION WITH SMA SYSTEM Pag. 20
12 CALIBRATION WITH PARALLEL BEAMS Pag. 21
13 ALARM SENSITIVITY ADJUSTMENT Pag. 22
14 TECHNICAL CHARACTERISTICS Pag. 23
Installation recommendation

Verify that the beam tower is fully watertight once the cover and end caps have been correctly filled at the
end of the installation.

Use the cable glands supplied on the tower for all cabling must pass through the lower end cap using the
cable glands supplied. The missed used of proper accessories decrease the IP grade protection of the
tower.

Avoid any type of obstruction between the transmitter and receiver.

Avoid installing the receivers beams in a position where direct sunlight, at the same angle as the receivers
beams, can enter directly into optics especially at sunset and sunrise

Do not install multiple beams where the transmitter beam can interfere with other receiver beams. It is
always better place either transmitter or receivers back to back.