12
EN
2.5.4 Surface control
•
Check that the cleaner fi lter is clean so as not to aff ect the cleaner's behaviour.
•
Once the cleaning cycle has been launched, monitor the cleaner's behaviour when climbing the walls and when it
brushes the waterline.
•
You can use the
(Surface Control System) butt on at any ti me depending on the cleaner's behaviour:
refer to the
table below.
•
The new confi gurati on will be eff ecti ve the next ti me the cleaner climbs the walls.
•
2 LEDs are lit by default
.
Cleaner behaviour to be observed
Acti on
The cleaner quickly climbs the walls and goes past the
waterline, aspirating air:
Reduce the number of LEDs.
Press:
The cleaner slowly climbs the walls and stops below the
waterline:
Increase the number of LEDs.
Tip: Opti mise wall cleaning and water line brushing operati ons
According to the type of pool lining, the cleaner will behave differently when climbing the walls. The cleaner
has the
function to optimise
wall cleaning, then waterline brushing
on all types of lining.
However the
functi on is set, the sucti on power remains at its maximum at all ti mes when the cleaner
is moving across the fl oor of the pool.
