Polaris Timbersled ST 120 RAW 2019, Руководство пользователя

Страница: 38 / 70

TRACK WARM-UP
WARNING
A loose track or flying debris could cause serious injury or death. Stand clear of
the front of the snow bike and the moving track. Never hold the snow bike off
the ground or stand behind it while warming up the track. Do not use excessive
throttle during warm-up or when the track is free-hanging. Use a stable rear
support.
WARNING
Use of traction products such as studs, ice growsers, etc. will increase the
possibility of track damage and/or failure. This could cause loss of control,
resulting in serious injury or death. Always inspect for track damage before
operating the snow bike.
Follow these steps to ensure proper warm-up of the engine, drive train and
track.
1. Use an appropriate stand to securely support the rear of the snow bike at the
rear bumper. The track should be about 4 inches (10 cm) off the ground.
2. Start the engine and allow it to warm up two to three minutes.
3. Engage the throttle abruptly and allow the track to rotate several revolutions.
TIP
It will take longer to warm up the track sufficiently during colder outdoor
temperatures.
4. Release the throttle, apply the brakes, shut off the engine and lower the
snow bike to the ground.
5. Grasp the ski by the front loop and move it from side to side to loosen snow
and ice.
SLIDE RAIL AND TRACK COOLING
NOTICE
Inadequate cooling and lubrication will lead to overheating of the slide rail and
track, resulting in premature wear and failure. Reduce speeds and frequently
drive into fresh snow to allow adequate cooling and polishing of the slide rail
and track surfaces. Avoid operating on ice, hard-packed surfaces or roads.
36
OPERATION