Polaris Sprotsman 700, Инструкция по безопасности и техническому обслуживанию

Страница: 61 / 148

59
CONTROLS AND FEATURES
Features
Rider Information Center
Mode 4 - Programmable Service Interval
The purpose of the programmable service interval is to provide the
consumer and their dealer with a convenient way to schedule routine
maintenance. When your vehicle leaves the factory, this feature is
turned “OFF”. You must enable this feature if you intend to use it to
track maintenance requirements.
The service interval mode operates by service hours. To set the hours,
press and hold the mode/override button until the wrench icon flashes.
When it begins to flash, release the button. At this point, each time the
button is pressed, the setting will increase by one hour. Pressing and
holding the button will allow the numbers to escalate much faster.
When the desired time increment is displayed, release the button and
wait for the wrench to stop flashing. When the wrench stops blinking,
your service hours are set.
NOTE: If you scroll past the intended
number, hold the button down until the count turns over to “0”. At this
point you can re-attempt to set the number.
Once the service interval mode is set, it will count down to “0”
according to the hours your engine is running. When the counter times
out at “0”, the wrench icon will flash quickly for 5 seconds every time
the vehicle is started as a reminder that the next periodic maintenance
is due.
If the service interval is enabled on your ATV and you wish to turn it
off, toggle to the service interval mode. Press and hold the mode
button for approximately 7 seconds until the word “OFF” appears in
the Rider Information Center.