Polaris RANGER EV 2015, Руководство по обслуживанию

Страница: 53 / 247

2
9926595 R01 - 2015-2016 RANGER EV Service Manual
© Copyright Polaris Industries Inc.
2.7
FINAL DRIVE / WHEEL AND TIRE
WHEEL AND HUB TORQUE TABLE
ITEM SPECIFICATION
Steel Wheels Lug
Nuts
35 ft-lb (47 Nm)
Front Hub Nut
70 ft-lb (95 Nm)
Rear Hub Nut
110 ft-lb (150 Nm)
WHEEL REMOVAL
1. Place vehicle on a level surface.
2. Turn key off and set parking brake.
3. Block front and rear edge of tires on the side
opposite the wheels to be removed.
4. Loosen wheel nuts slightly.
5. Elevate side of vehicle by placing a jack or lift under
the frame. Place blocks under frame for additional
safety.
WARNING
Care should be taken to be sure the vehicle is securely
supported and blocked to prevent movement when
elevated. Failure to follow the safety precautions could
result in serious injury or death.
6. Remove wheel nuts and washers (or lug nuts) and
remove wheel.
WHEEL INSTALLATION
1. Place wheel on hub. Be sure valve stem is outward
and rotation arrows on tire point in forward rotation.
2. Install washers and wheel nuts (or lug nuts with
tapered end toward wheel) and tighten lightly by
hand until wheel is centered and firmly supported.
3. Remove safety supports and lower the jack.
4. Tighten wheel nuts (or lug nuts) to proper torque
listed in the Wheel and Hub torque table on Wheel
and Hub Torque Table, page 2.7.
CAUTION
If wheels are improperly installed it could affect vehicle
handling and tire wear. On vehicles with tapered lug
nuts, be sure tapered end of nut faces the wheel.
TIRE PRESSURE
WARNING
Maintain proper tire pressure. Refer to the warning tire
pressure decal applied to the vehicle.
TIRE PRESSURE INSPECTION (COLD)
Front Rear
20 psi (138 kPa) 20 psi (138 kPa)
TIRE INSPECTION
• Improper tire inflation may affect vehicle
maneuverability.
• When replacing a tire always use original equipment
size and type.
• The use of non-standard size or type tires may affect
vehicle handling.
Tire Tread Depth
Always replace tires when tread depth is worn to 1/8" (3
mm) or less.
MAINTENANCE