Polaris RANGER EV 2015, Руководство по обслуживанию

Страница: 206 / 247

8.6
9926595 R01 - 2015-2016 RANGER EV Service Manual
© Copyright Polaris Industries Inc.
SWITCHES / CONTROLS
HEADLIGHT SWITCH
VOLTAGE LEVEL: 14.0 VDC
LOCATION: On Dashboard.
SYSTEM
WIRING DIAGRAM REFERENCE: See
Lighting System Wiring Diagram, page 8.29.
OVERVIEW: Headlight power is supplied to the headlight
switch via the RD/YE wire leading from the 10A LIGHTS
fuse (located in the fuse box under the hood), through
Pin 10 of the Chassis to Dash connector block. Power
enters the headlight switch on terminal 2.
When the headlight switch is in the OFF position, power
entering terminal 2 of the switch flows through the RD/YE
jumper wire to terminal 6, through the switch lamp to
terminal 7 and 8, then to ground on the BN wire.
When the headlight switch is ON, power flows from
terminal 2 to terminal 3 (DG), back through the Chassis /
Dash connector Pin 11 and on to the headlights. Note
that in the ON position the other switch lamp is powered
and ground path is through terminal 8 (BN).
If the headlight switch lamp is illuminated with the key
switch ON, power is reaching the switch through the
fuse. If switch lamp does not turn on with key switch,
check the fuse. If fuse is good (and powered), test for
power on the RD/YE wire (terminal 2) of the switch
harness. If power is present, test switch continuity and
ground path on the BN wires in the harness.
Headlight Switch Power and Ground Testing
NOTE: If switch is illuminated, this test is not required.
The ground is for switch lighting only.
1. Open hood. Reach under the dash and press tab on
headlight switch connector to disconnect wire
harness from switch. Do not pull on wiring.
2. Turn key switch ON.
3. Verify 12-14Vdc is present on the RD/YE wire.
4. Turn key switch OFF.
5. Verify ground path of BN wire (s) to the negative (-)
terminal on the controller with an Ohmmeter.
Headlight Switch Testing
6. Open hood. Reach under the dash and press tab on
headlight switch connector to disconnect wire
harness from switch. Do not pull on wiring.
7. Remove headlight switch from the dash.
8. Verify continuity exists between terminals 2 (RD/YE)
and terminal 3 (DG) when the switch is in the ON
position.
• When the headlight switch is turned on, there should
be continuity between terminals 2 (Yellow) and 3
(Green).
NOTE
Disconnect the Main Power Connector (see chapter 1)
before disconnecting any electrical component. The
Main Power Connector is the first to disconnect and the
last to connect when servicing the electrical system.
AWD / 2WD / TURF SWITCH
VOLTAGE LEVEL: 14.0 VDC
LOCATION: On Dashboard.
SYSTEM WIRING DIAGRAM REFERENCE: See AWD
System Wiring Diagram, page 8.31.
OVERVIEW: Power supply from terminal A8 of the fuse
box (RD/BK) is connected through Pin 9 of the Chassis
to Dash harness connector to terminal 2 of the AWD
switch.
Power entering terminal 2 is switched as follows:
ELECTRICAL