Polaris PVCR 3300 IQ Home Aqua, Руководство по эксплуатации, Страница: 82 / 185

82
To improve the cleanup quality, the vacuum cleaner features a set of programs which can be started from
the control unit or from the application.
The suction power can be changed under any of the cleanup modes. For this, push button on the
control unit, and the suction pump increases. The next push leads to the power decrease.
Prior to launching cleanup programs, make sure the robot is activated.
1.
Classic or main cleanup program. Fig. 13-A
To launch it, push button on the robot, button on the control unit, or click on AUTO
in the application. The acoustic message about starting the main cleanup mode follows.
2.
Spiral motion (targeted vacuuming). Fig. 13-B
The spiral motion program (targeted vacuuming) is intended for vacuuming a heavily contaminated local
area. The program can be launched from the application. The launch is preceded by acousting message
about the targeted vacuuming mode.
3.
Wall-along cleanup. Fig 13-C
To start the "Wall-along" cleanup mode, push respective button on the control unit, or click on
respective button in the application. The respective acoustic message follows.
CURRENT TIME AND CLEANUP START TIME SETUP ON THE CONTROL PANEL.
By manipulating buttons on the control unit, you can set the cleanup start time at the timer. At that, the
current time shall also be set.
At having the timer adjusted, the vacuum cleaner automatically turns on, and starts vacuuming every day
at a preset time. The I/O switch on the appliance body shall be turned on, the charge base shall be installed
and connected.
ATTENTION: THE CONTROL UNIT DURING ADJUSTMENT SHALL BE ORIENTED
TOWARDS THE VACUUM CLEANER, THE LATTER SHALL BE SWITCHED OFF.
Current time adjustment.
Push button on the control unit. This causes the "hours" indicator flashing on the display.
Manipulate buttons or to set a desirable time, and or to switch over from hours
to minutes and back. To save the settings, push button on the control unit. The beep about saving the
settings follows.
Cleanup start time adjustment.
Push button on the control unit what is followed by the acoustic message about the cleanup start
time setup mode. This causes the "hours" indicator flashing on the display. Manipulate buttons or
to set a desirable time, and or to switch over from hours to minutes and back. To save
the settings, push button on the control unit. The beep about saving the settings follows.