Polaris AutoClear SC PAGSC20K, Инструкция по установке и эксплуатации

Страница: 9 / 72

Page 9
ENGLISH Polaris ® AutoClear TM SC Salt Chlorinator
|
Installation and Operation Manual
Section 3. Installation Instructions
WARNING
FOR YOUR SAFETY:
This product must be serviced
by a professional pool/spa service technician as
described on the front cover of this manual. The
procedures in this manual must be followed exactly.
Failure to follow warning notices and instructions may
result in property damage, serious injury, or death.
Improper installation and/or operation may void the
warranty.
EQUIPMENT UNDER PRESSURE:
Always turn
pump off prior to installing or servicing the chlorine
generating device. Your pump/filter system is
operated under pressure and the pressure must be
released before you begin work. Please see your
pump/filter owner’s manual for further instructions.
WARNING
To reduce the risk of electric shock, do not use an
extension cord to connect unit to electric supply;
provide a properly located outlet. Inspect cord before
using – Do Not Use If Cord Is Damaged.
WARNING
Risk of Electric Shock. Connect only to a branch
circuit protected by a ground-fault circuit-interrupter
(GFCI). Contact a qualified electrician if you cannot
verify that the circuit is protected by a GFCI. Do Not
Remove Ground Pin.
CAUTION
To reduce the risk of electric shock do not place the
power pack closer than 6 ft (1.8 m) to the pool. In
Canada, at least 3 meters (10 feet) horizontally from
the edge of the pool and/or spa.
Do not bury the cords. Locate cords to minimize
abuse from lawn mowers, hedge trimmers, and other
equipment.
WARNING
RISK OF ELECTROCUTION. Do not touch plug with
wet hands.
Before you begin your installation, please check that
you have the right tools and a suitable location to install
the power pack and cell. Please ensure that you have
read and understood the Important Safety Instructions
section.
3.1 Materials and Tools
Installation Materials Furnished
• Pipe spacer - for 1½ in. (40 mm) pipe
• Screw set (includes wall plugs)
• Installation and Operation Manual
3.2 Installation Requirements
WARNING
The chlorine generating device must be installed
horizontally with the cell above the pipe to avoid
buildup of flammable gases which can result in FIRE
OR EXPLOSION. The chlorine generating electrolytic
cell must be installed outdoors.
It is required that the water flow pod is installed in the
same piping as the electrolytic cell, without any valves
or diverters between them.
The flow switch must be mounted as shown.
Flex Hose*
(*Not to scale)
Flow Switch
Power Pack
Cell
Pod
Figure 3. Installation Requirements
The installation requirements for the chlorine generating
device are as follows:
•
The power pack must be installed at least 2 feet
(0.6 m) vertically off the ground.
•
The power pack must be installed at least 6 feet
(1.8 m) from the inside wall of your swimming pool
or spa. In Canada, at least 3 meters (10 feet).
•
The cell must be installed with the provided pipe
adapter.
•
The cell must be installed no more than 7 feet
(2.1 m) from the power pack.
•
The power pack must be installed no more than
3 feet (1 m) from an electrical outlet.
•
The flow switch pod must be installed upstream
from the cell.
•
It is recommended that the flow switch and cell be
installed 10 in. (0.25 m) from any 90° elbow.