Polaris Alpha iQ, Руководство пользователя

Страница: 9 / 84

Page 9
English
2. Grip the notched end of the floating power
cable, insert into the control box, and turn
clockwise to tighten. (Figure 11.)
3. Plug the control box directly into a GFCI
outlet. DO NOT use an extension cord.
Figure 11. Connect Floating Cable
NOTE: To avoid damaging the power cable, do not
try to twist the entire cable housing (see below).
X
X
X
X
NOTE: To avoid exposing the power cable
connector pins to water, be sure the connector is
screwed in all the way and there is no gap. (see
below).
X
X
X
X
4
General Cleaner
Operation
CAUTION
To prevent damage to the cleaner, be sure to
adhere to the following guidelines:
• Remove the cleaner from the pool after the
cleaning cycle is completed.
• Store on the caddy out of direct sunlight or
inclement weather.
• Never lift the cleaner out of the pool by the
floating cable. Always use the lift feature to
remove cleaner from the pool.
• Take additional care when lifting the cleaner out
of the pool. It becomes heavier when filled with
water.
• Always remove the cleaner from pool when super
chlorinating or adding acid.
• Do not handle cleaner while it is in operation.
IMPORTANT
• Always make sure the cleaner head is fully
submerged before you begin operation.
• Clean the filter canister after each cleaning
cycle.
• Do not leave your cleaner in the pool on a
permanent basis.
• At the end of each cycle, remove the cleaner
from the pool.
• Start at the cleaner head and untangle any
coils in the cable before storing the cleaner.
The Polaris robotic cleaner includes a safety
feature that automatically stops the cleaner if it is
powered on but not submerged in water. For pools
equipped with a beach area, this safety feature is
programmed to drive the cleaner in reverse and
back into the pool when the impeller is out of the
water.