Instr 9928802
Rev 01 2018-06
Page 8 of 8
c. Place intake tube
F
back into position and
secure with previously removed dart clip
fasteners
G
. Replace cable tie
H
to secure
lower portion of intake tube.
IMPORTANT
Ensure the mating joint between the upper intake
plenum and the intake tube is completely engaged
all the way around the mating joint. Failure to do so
may result in premature engine failure.
d. Reconnect ECU by plugging the chassis
electrical harness connector
J
in the ECU
K
.
10.
REINSTALL HOOD.
a. Install hood being sure to connect the hood
harness
A
and chassis harness
B
connection.
Replace cable tie
C
if applicable. Secure hood
into position with hood latch fasteners.
11.
REINSTALL SIDE PANELS.
a. After installing hood, install both side panels
making sure all hood latches and rubber straps
are fully secured.
12.
VERIFY WORK.
a. Check to ensure all tools are accounted for and
all steps have been completed.
FEEDBACK FORM
A feedback form has been created for the installer to provide any comments, questions
or concerns about the installation instructions. The form is viewable on mobile devices
by scanning the QR code or by clicking
if viewing on a PC.
FEEDBACK FORM
