Instr 9928802
Rev 01 2018-06
Page 2 of 8
TOOLS REQUIRED
• Safety Glasses
• Pliers, Push Pin Rivet
• Pliers, Side Cutting
• Socket Set, Metric
• Socket Set, Torx
®
Bit
• Torque Wrench
• Wrench Set, Metric
IMPORTANT
Your HANDLEBAR BAG WITH PHONE CHARGER KIT is exclusively designed for your vehicle. Please read the
installation instructions thoroughly before beginning. Installation is easier if the vehicle is clean and free of
debris. For your safety, and to ensure a satisfactory installation, perform all installation steps correctly in the
sequence shown.
ASSEMBLY TIME
Approximately 30 minutes
NOTE
Additional time may be required for optional steps, or
to accommodate other installed accessories.
INSTALLATION INSTRUCTIONS
CAUTION
BEFORE STARTING INSTALLATION
, always
ensure vehicle is properly secured on a flat stable
surface to avoid accidental tipping, unwanted
movement and to prevent personal injury and/or
damage to equipment. Turn key to “OFF” position
and remove from vehicle.
NOTE
Images shown may vary from your specific model
vehicle. Installation steps are similar between
models unless otherwise specified.
1.
REMOVE SIDE PANELS.
2.
REMOVE HOOD.
a. Slightly lift the rear of the hood assembly to
gain access to the main hood harness
connector
A
and disconnect from main
chassis harness connector
B
. If applicable, cut
the cable tie
C
securing the hood harness to
the chassis and remove hood.
