Instr 9926739
Rev 02 2018-09
Page 3 of 9
INSTALLATION INSTRUCTIONS
1. Shift vehicle transmission into “PARK”. Turn
ignition switch to “OFF” position and remove key.
2. Remove all seats.
WARNING
Ensure red positive (+) battery terminal is
COMPLETELY COVERED by protective boot.
Accidental tool contact across both battery terminals
will result in high current electrical arc, and may
result in battery explosion. Death or serious personal
injury may occur.
Black negative (-) cable MUST be disconnected from
battery terminal. Failure to disconnect cable may
result in electrical arc when installing connections at
terminal block. Death or serious personal injury, or
damage to vehicle or accessory, may occur.
3. Remove passenger (or right rear passenger)
storage compartment, then disconnect black
negative (-) cable from battery.
4. Remove hood.
5. Remove four push pin rivets
A
from center floor
console, and one on each side by foot pedal.
Remove floor console. Retain fasteners.
CONTACTOR AND WIRING INSTALLATION
WARNING
Do NOT reconnect black negative (-) cable to battery
terminal in the next step. Reconnecting cable may
result in electrical arc when installing connections at
terminal block. Death or serious personal injury, or
damage to vehicle or accessory, may occur.
1. If not previously installed, install Battery
Connection Kit (PN 2879388, 2879685, or
equivalent; sold separately) at this time.
Follow instructions included with Battery
Connection Kit. However, do NOT tighten battery
cable terminals at terminal block, and do NOT
reconnect black negative (-) cable to battery
terminal.