4. Dry the interior and exterior with a soft cloth.
5. When the machine is not being used for long time periods, drain water completely
from water reservoir.
6. Like most appliances, your ice maker requires periodic maintenance for maximum
efficiency and performance and must be cleaned on a regular basis. (i.e. every
4 months) To maintain a hygienic environment within your ice maker and prevent
potential formation (growth) of bacteria, we strongly recommend regular cleaning
of your ice maker using a Cleaning kit. These kits are available through our
customer Service Department at
1-866-253-0447 or can be ordered on line at
www.greenwayhp.com
operating Instructions
1. Connect the ice maker to a standard 120Volt, 60Hz three-prong (grounded)
electrical outlet. The green indicator light (above the power on/off button) will start
flashing indicating the unit is in “standby” mode.
2. Open the lid cover and remove the ice basket and ice basket baffle.
3. Add water to the “MAX” fill line indicated on the rear wall of the reservoir
compartment. (Do not overfill)
4. Install (slide) the ice basket baffle onto the top rear side of the ice basket making
sure the notched side of the baffle is positioned on the right side of the basket.
(sensor side) To promote maximum ice storage capacity, we recommend the ice
basket baffle always be installed when the ice maker is operational.
5. Reinstall the ice basket into the storage compartment.
6. Press the power “A” (on/off) button, the “green” indicator light will change from
a flashing (standby) condition to a steady state (on) condition, indicating the unit is
now operational.
7. Press the selector “B” button to select between the 3 desired ice cube sizes. (small,
medium, large) The corresponding (green) light will illuminate directly above the
selection made.
8. While the ice maker is operational, periodically check the reservoir water level. If
the water reservoir is empty, the pump cannot inject water and the ice maker will
stop automatically causing the “Add Water” (D) indicator light to illuminate. Fill
the reservoir to the “MAX” fill water level and re-start the machine by pressing the
“power” (on/off) button again. Failure to re-start the machine will result in
continuous “standby” mode.
7
