Instruction manual
S12-250 ver. 2018
9/15
- loosen the counter nuts of the adjustable
feet using the wrench (item 8),
- put the base board (item 2) into the tray,
- place the white take-off board (item 3) on
the base board (item 2), check the level
with the runway surface (see k, drawing 3),
- remove the white take-off board (item 3),
- use the included hex key (item 9) to
adjust the required feet (see g, drawing 3),
- put the white take-off board (item 3) on
the base board (item 2),
- check again the level with the runway
surface (see k, drawing 3),
- if the white take-off board is on the
correct level, use the wrench to screw
down the counter nuts to block the feet,
- if the level of the white take-off board is still incorrect, continue to adjust the feet.
