POINT POD Compact V1, Руководство пользователя

Страница: 10 / 14

10
Installation
Point Pod products should only be installed by a qualified professional.
Stone Installation
Step 1. Remove the Point Pod from the box and check everything is present and accounted for .
Step 2. Carefully mark out where the unit is to be installed, taking into account the void the
unit needs under the bench top .
Step 3. Drill 100mm OD hole in the stone bench top using a fit for use 100mm holesaw.
Alternatively, cut the holes with a water jet . Dimensions needed are 100mm for the outer hole
and 92mm for the inner disc .
Step 4. Silicone or glue the outer collet into the hole making sure it sits flush with the top of the
bench surface .
Step 5. Once the silicone or glue has cured, adhere the mounting flange to the underside of the
stone positioned around the outer collet . This should be adhered using Megapoxy or similar
product .
Step 6. Once the mounting flange is set in place and Megapoxy or similar product has set,
install the Point Pod unit from the top and lower it down until it is sitting flush with the outer
collet and has an even margin around . Fix the unit in place by placing the fastening clip
supplied to the mounting flange and tightening appropriately.
Step 7. Set height adjuster screws in the receiving cup to the right height for your disc insert .
Glue the disc in place with silicone or preferred adhesive making sure to line up all features of
the stone .
Step 8. After the stone top has dried, plug the unit in ready for testing . The unit has a 30
second delay when first plugged and then when activated will travel in the downwards motion
first. Activate the unit again by pressing on the top and the unit should rise up to the open
position . Activate again and it will lower back down . In this closed position double check the
height and margins and adjust where necessary .
The unit is now ready for everyday use .
Follow the QR code link for installation video