PNI Escort Start 360, Руководство пользователя

Страница: 31 / 171

30
negative polarity before engine start and with +12V after engine started.)
WARNING: Please be sure that you use the remote engine start function only while the
gear selector is in neutral or park position and the hand brake is engaged.
2 1 . Remote start crank time programming: 0.8/1.1/1.4/1.7/ 2.1/2.4 seconds
While the alarm system is disarmed, turn the ignition ON then stay ON, press
and hold the brake pedal, then press and release the Override/Valet Switch 5 times, the
siren will chirp once to indicate the system has entered the programming mode.
While the system is in programming mode:
a. Press the Override/Valet Switch once, the siren will chirp once, the turn signal lights
will flash once, indicating the 0.8-second crank time is selected.
b. Press the Override/Valet Switch once again, the siren will chirp twice and the turn
signal lights will flash twice, indicating the 1.1-second crank time is selected.
c. Continue pressing the Override/Valet Switch till the 2.4-second crank time is
selected, the siren will chirp 6 times and the turn signal lights will flash 6 times.
d. When the 2.4-second crank time is selected, if you press the Override/Valet Switch
again, the siren will chirp once, the turn signal lights will flash once and resume the
crank time setting to 0.8 second. After a desired crank time is selected, release the
brake pedal, the siren will chirp twice and the system will exit the programming mode.
Note: In each setting, the engine will have 3 attempts in remote starting the vehicle. The
default setting is 0.8 second. In this setting, the 1st attempt is at 0.8, 2nd attempt at 1.1,
and 3rd attempt at 1.4. When power supply is interrupted, remote start crank time will
resume its default setting at 0.8 second on 1st attempt.
2 2 . Remote engine start for manual transmission cars
In order to remotely start the engine of a manual transmission car, driver must
first set the system to reservation mode every time before leaving the car after parking,
otherwise, the remote engine start will not work.
Procedure:
- After parking the car, push the gear lever to neutral before turning off the engine.
- Activate the hand brake and release the brake pedal.
- Pull out the ignition key, the engine will keep running for 2 minutes.
- Get off the car and close all the doors properly within these 2 minutes, the engine will
shut down and the remote start reservation is set successfully and remote engine start
can be used before next driving. This is to ensure that the gear is in neutral position
when remotely starting the engine.
Examples of failure to set remote start:
A. During the 2-minute engine run time, if the door is opened without closing and the
engine shut down, the setting will fail.
B. After the remote start reservation is set successfully, open the door again or start the
engine again, the reservation will be cancelled.
C. If the door-opened alarm or the ignition alarm occurred while the alarm is armed, the
remote start reservation will be cancelled.
30
EN