PNI Sensor
DOC# : PlacePod Installation Guide R01_draft7
Page 11 of 14
6.2
PREPARING PLACEPOD FOR ADHESIVE
1. Using coarse sand-paper, lightly sand the bottom gray portion of the housing, scuffing
the surface.
Figure 13: Sand gray part of housing to scuff surface
2. Wipe off any residual particulates from the sanding.
6.3
INSTALL THE PLACEPOD W ITH ADHESIVE
1. If mapping of the sensor location is being performed, record the Serial Number.
2. At minimum, apply a 1/8” to 1/4” bead of adhesive around the outer and inner rings of
the PlacePod.
3. If desired, adhesive can be applied to the ribs and to the sensor lower housing (black)
areas NOT covered by the label.
Figure 14: Apply adhesive to outer ring and any additional ribs of the gray housing
4. To optimize signal strength orient the sensor in the middle of the space such that the
arrow points towards the nearest gateway.
5. Place the sensor on the ground and press down on it firmly.
6. If desired, apply an additional bead of adhesive around the seam of the sensor and the
pavement.
Note: If you intend to also screw the PlacePod down ensure that you align the PlacePod with
the pre-drilled screw holes.
6.4
INSTALL THE PLACEPOD W ITH SCREW S
