Pneumax 120-60-DS, Руководство по установке

Страница: 7 / 40

Pneumax CAFS "DS" Series Installation Guide
Page 7 of 40
Installing the Pneumax DS CAFS
Refer to the Basic CAFS schematic in this manual to see how the components connect to
the vehicle's foam and water distribution systems. Within the guidelines given here,
components can be installed wherever there is room for them to be securely mounted. See
the dimensional drawings in the rear.
Warning: Do not damage the vehicle chassis (also called frame or undercarriage) during
installation. Check with the vehicle manufacturer to make sure the planned
welds and bolts are in acceptable areas.
•
The module must be bolted to brackets welded to the pump compartment frame, or
bolted directly to the pump compartment frame.
•
The module must have the specified unobstructed clearances for cooling.
•
The fuel tank must be installed with no more than the specified height differentials
between tank and fuel inlet. If this height differential must be exceeded, a fuel pump
capable of providing adequate fuel flow must be installed.
•
Allow enough clearance at the sides of the module for routine maintenance. Most
maintenance can be performed through the top access doors, but service hatches at
the sides can make maintenance easier.
Lifting instructions
Warning: Make sure the lift and chains are rated to lift the weight of the CAFS system.
Using a Forklift
The system's drains are mounted on an
apron at the bottom of the unit. This
covers the frame.
Remove the apron at the bottom of
the system before fork-lifting.
Leave clearance between the CAFS
system and the front of the forklift to
avoid damage to the controls on the
front of the system.
Apron with drains