The Evo is a semi-auto only marker that is designed for tournament play. It does not have full auto
or burst features
.
SAFETY:
When you turn the marker on by holding the on/off button for three seconds, it automatically
goes into "safe mode." To turn the safety off, press the on/off button once lightly. The red on/off indicator will
turn on and the marker is now ready to fire. To turn the marker back on safety, press the on/off button once
and the red active indicator will turn off. To turn the marker off hold the on/off button for three seconds while
it is in safe mode. The frame should be left off when not using the marker or you will drain the battery.
WARNING:
Never use water to clean the marker, or you
run the risk of damaging the electronic trigger frame.
00 00
Eye
Indicator
Counter/Timer
PMI Piranha: EVO
27
ON/OFF BUTTON:
The on/off is the silver button located on the left hand side of the gripframe.
Push and hold it in for three full seconds to turn your Evo LCD on. The LCD will turn on, but the marker is
in "safe mode." Press the on/off button again and the safety will turn off. The red on/off indicator will then
light up.
28
ODOMETER:
The Evo must be in "safe mode" to view the odometer. Press the A button to view
the odometer.
TIMER:
The Evo must be in "safe mode" to change the timer settings. Press button B on the right
hand side once to change settings. Once the numbers are blinking use button A to increase timer clock by
one minute increments. Press button B once when the countdown time is set and the numbers will stop
blinking. To start the timer, turn the safety off and fire the marker once.
ANTI-CHOP EYE (ACE):
When the ACE is activated, it will only allow you to fire when
there is a paintball in the chamber. When the ACE is off, the rate of fire defaults to a slower setting so
you won't chop paint. However, this means you will not be able to dry fire the marker quickly. To turn the
ACE on or off, press button B on the right hand side of the frame while the marker is ready to fire. The
Eye logo on the LCD will only appear while the ACE is turned on.
LCD DISPLAY
Cleaning The EYE:
If the Evo Anti-Chop Eye doesn’t function, then verify that the eye is
turned on. If the Eye is on and Evo fires without a paintball in the breach, then there is probably dirt or
paint on the eye itself. Clean off the eyes and test again. It is possible for an authorized repair shop to
remove the eye itself for cleaning, but a squeegee should clean away enough paint to make the eyes work
right away.
To test Eye function, (treat the marker as though it was
loaded for this test):
1. Turn marker on
2. Cock marker
3. Verify that the Eye is on by checking for the Eye Indicator on the LCD
4. Remove hopper to make sure there is no paintball in the breach
5. The marker should NOT fire when the trigger is pulled
INSTRUCTIONS FOR USING YOUR EVO
PMI Piranha: EVO
EVO Battery:
The Evo comes with a 9 volt rechargeable battery. You must charge it for a full
22 hours before initial use since it does not come fully charged. For best long term battery life, repeat
this process every time it is drained. You can also use a regular 9 volt battery with this frame if your
rechargeable battery is dead or if you want to play with the frame right away. You will need to remove the
right grip panel to replace the battery.
Button A
Button B
Active Indicator
ODOMETER:
Accumulate odometer readout can be zeroed out by holding button B for 15 seconds
while on/off switch is turned to safe mode.
WARNING:
Take extra safety precautions when handling or
shooting the Evo as paintball markers with electronic frames have
EXTREMELY sensitve triggers.
