PMI RECOMMENDS THE INCLUDED 9V RECHARGEABLE BATTERY FOR
OPTIMAL PERFORMANCE. DO NOT USE THE BATTERY CHARGER WHEN
USING ANY NON-RECHARGEABLE BATTERY.
PMI PIRANHA
®
eFORCE
32
31
BURST BUTTON
Press the Burst Button once to turn the marker on 3 Shot Burst. Press the Burst Button again to
turn the frame to 6 Shot Burst. Press the Burst Button again to turn the frame to 9 Shot Burst.
Press the Burst Button again to turn it back to semi-auto.
FULL AUTO BUTTON
Press the Full Button once to turn the frame to Full Auto. Press the Full Button again to turn it
back to semi-auto.
W
WA
AR
RN
NIIN
NG
G
!
W
WA
AR
RN
NIIN
NG
G
!
NEVER USE WATER TO CLEAN THE MARKER, OR YOU RUN THE RISK
OF DAMAGING THE ELECTRONIC TRIGGER FRAME.
SEAR RELEASE SLIDE
The sear release slide is located on the left hand side of the eForce grip frame. To reinstall the
bolt/block/hammer assembly, push the sear release slide up before the hammer comes in contact
with the sear. That will allow the bolt/block/hammer assembly to slide easily into the marker.
INSTRUCTIONS FOR USING YOUR eFORCE FRAME
PMI PIRANHA
®
eFORCE
ON/OFF BUTTON
The on/off is located on the left hand side of the marker. Push it once to turn your eForce on. Push
it again and the frame will turn off. The frame should be left off when not using the marker or you
will drain the battery. Use the on/off button as the safety.
eFORCE BATTERY
The eForce frame comes with a 9 volt rechargeable battery. You must charge it for a full 22 hours
with the marker turned off before initial use since it does not come fully charged. For best long
term battery life, repeat this process every time it is drained. You can also use a regular 9 volt
battery with this frame if your rechargeable battery is dead or if you want to play with the frame
right away. You will need to remove the right grip panel when you need to replace it. A blinking
on/off indicator light means your eForce frame needs to be charged right away. Always charge with
the marker turned off.
To access the Tournament Lock, you have to take the
eForce frame off the receiver and unscrew the two phillips
head screws (#13) that hold the board cover (#14) in
place. Once these are out, the cover can be lifted and the
small blue switch can be moved to put the marker on
Tournament Lock.
lock off
lock on
TOURNAMENT LOCK SWITCH
The Tournament Lock Switch enables you to play in a
tournament or at a field that does not allow full auto
and burst modes by restricting the marker to semi-
automatic only. All eForce frames come with the
Tournament Lock off so you can immediately put the
marker in full auto or burst mode.
Battery
Indicator Light
Charge Port
Sear Release Slide
On/Off Button
*Adjustable modes of fire and rechargeable frames are not currently available in all countries.
W
WA
AR
RN
NIIN
NG
G
!
TAKE EXTRA SAFETY PRECAUTIONS WHEN HANDLING OR SHOOTING SINCE
MARKERS WITH ELECTRONIC FRAMES HAVE EXTREMELY SENSITVE TRIGGERS.
