Plinius SA-REFERENCE, Инструкция по эксплуатации

Страница: 20 / 22

18
MAINS/LINE FUSE
A Mains/Line fuse is fitted within the IEC Mains/Line socket on the rear of the amplifier.
A small drawer at the bottom of this socket may be removed (after the IEC plug is
removed) by levering it out with a flat blade screwdriver. The fuse fitted should be
rated as specified on the rear panel.
In the unusual event that this fuse should blow, you must first establish the cause of
this failure (such as power surges, damaged mains cable etc.) before replacing the
fuse with one of the same rating and type.
IMPORTANT: DO NOT FIT A FUSE WITH A HIGHER RATING.
NOTE: Fuse failure may indicate a severe problem. Should the amplifier continue to
exhibit mains fuse failure contact your Plinius dealer.
LOUDSPEAKER SELECTION
Your PLINIUS SA-Reference Power Amplifier is designed for use with high fidelity
loudspeakers. It should not be used to operate any other type of appliance or equipment.
Choice of loudspeakers is one of personal taste, providing the chosen loudspeakers
are suitable for use with your amplifier. Be certain that your loudspeakers can
handle most of the rated output power of this amplifier. You may find loudspeaker
specifications confusing or misleading so you should discuss this with your audio
dealer prior to purchase. As a general rule, the use of high power (200 watt RMS
or greater) loudspeakers is recommended and desirable. However, our experience
indicates that medium to low power loudspeakers (100 to 200 watt RMS) are quite
often suitable for use with this amplifier provided the volume is maintained at a level
where no distortion is audible.
Impedance of the loudspeaker load is important to ensure the rated performance of
this amplifier. Any combination of loudspeakers may be used but the total average
impedance load for each channel should be within a range of 4 to 8 ohms. Again,
if you have doubts about the impedance of your loudspeaker configuration, we
recommend you speak to your Plinius dealer.