Plinius SA-REFERENCE, Инструкция по эксплуатации

Страница: 18 / 22

16
CONNECTING THE MAINS SUPPLY
Firstly, check that the mains supply voltage printed on the rear of this amplifier is
similar to the mains supply voltage in your area. If in doubt, please consult your
Plinius dealer. Mains supply power connection is via the plug-in lead supplied with
your PLINIUS SA-Reference.
Check the wall outlet is switched OFF, then connect the local mains plug end of the
lead to the wall outlet. Check the SA-Reference is switched OFF, and connect the IEC
end of the cable to the IEC socket at the back of the SA-Reference. With the cord fully
connected, switch the wall outlet ON.
Now that your PLINIUS SA-Reference is configured correctly, switch the power switch
on the rear panel to ON. The display LED will cycle in brightness for approximately ten
seconds as the internal circuitry stabilises. Use the MUTE switch on the front panel
to take the unit out of MUTE and you can now enjoy your new PLINIUS SA-Reference
Power Amplifier.
NOTE: This unit must be connected to a mains socket outlet with a protective earthing
connection. The wall outlet socket or SA-Reference mains switch must be accessible
at all times in case of emergency.
WARM-UP PERIOD
You will find that the PLINIUS SA-Reference will become noticeably ‘purer’ in sound
after being on for a period of time. We usually recommend waiting at least 24 hours
before expecting the best quality of sound reproduction from your amplifier. We
suggest leaving the unit turned on so that it will always be at it’s sonic best.
SA-REFERENCE FEATURES
ERROR DETECTION
The PLINIUS SA-Reference Power Amplifier has in-built error detection. This will
function under the following conditions:
1) When the amplifier is overdriven/clipped
2) If any internal fuse is damaged
Should either of these circumstances arise the amplifier will disconnect both