Plextor PX-850A, Инструкция по установке и эксплуатации

Страница: 22 / 248

Section 2. Installing the PX-850A Internal PATA Drive
14
PX-850 Installation and Users Manual
Figure 3: Removing a typical computer's cover
Determine Your Existing IDE Configuration
With your computer open, determine the existing IDE configuration.
You can do this by looking at the IDE ribbon cable (or cables—there
may be two) and seeing what is connected to them.
One end of the IDE cable connects to the IDE port on your computer’s
motherboard; and there are usually two other connectors for attaching
peripheral devices such as a hard disk, DVD or CD-ROM drive, or your
PX-850A drive. If there are two devices, one is configured as
Master
and the other the Slave, as indicated by the position of jumpers on the
back of the drive.
If your computer is set up for Cable Select, or CSEL, both devices will
be jumpered as
Cable Select . In older computer, this configuration
required a special Cable Select cable.
If there are two IDE cables, one is for the
primary IDE bus and the other
is for the secondary bus.