Section 3. Using Your PX-716UF
PX-716UF Installation and Users Manual
27
Tray Loading and Operation
To load and unload the tray:
1. While the drive is powered up, push the eject button on the front
panel. The tray drawer slides out in 3–4 seconds.
Figure 7: Loading the tray
2. Lay a CD or DVD disc in the depression in the tray, label side up.
3. Press the eject button again and the tray will slide shut within
seconds.
NOTE
: Always use the eject button to close the tray in a smooth and
secure manner. Closing the tray by pressing the front of the drawer using
your hand is not recommended and risks damage or premature wearing
of the mechanism.
Handling DVD and CD Media
Take care when handling blank CD and DVD media. Dust, scratches,
and fingerprints on either side of the disc can cause write errors during
recording. When picking up or holding blank media you can either place
your fingers along the outer edge of the disc, or place one finger through
the center hole and one finger on the outer edge. Once you have finished
creating a disc, label it by writing on the top using permanent ink.
