Section 2. Installing the PX-716UF External USB/FireWire Drive
PX-716UF Installation and Users Manual
23
If You Have a Macintosh
If you have a Macintosh, use the following procedure to install your
PX-716UF drive:
1. Turn on the Macintosh.
2. Ensure you are running Macintosh OS 9.1 or higher (for FireWire
and USB 1.1) or OS X (for USB 2.0).
3. On the PX-716UF, set the rear-panel interface switch to USB or
IEEE 1394, corresponding to the interface you will be using.
4. Connect the AC adapter to your PX-716UF.
5. Turn the drive’s power switch ON (the “1” is depressed).
6. Connect the USB or IEEE 1394 cable from your PX-716UF drive to
the Macintosh computer.
The Macintosh automatically recognizes the PX-716UF (if the base
extensions are loaded), and you should be ready to use the drive as a
CD-ROM. To use the recording capabilities of the drive, a recording
application must be installed.
NOTE
: Most Macintosh USB built-in ports provide USB 1.1 Full-Speed
(12 Mbps). This limits the CD-RW drive performance to 4X write, 4X
rewrite, and 6X read. DVD read performance is 0.7X. For optimum
performance, if your Macintosh computer does not have built-in USB 2.0,
use the FireWire port. Or you can install a third-party PCI USB 2.0 plug-
in host adapter card.
ANOTHER NOTE
: For optimum performance if you use the USB
interface, you will also need Mac OS X. If you use OS 8.6.x or 9.x with a
built-in USB port or a PCI adapter, your PX-716UF will achieve only USB
1.1 performance.